Water Proof Electromagnetic Communication Rack Cabinet with Flexible Size YH9006
Ventilation and dust protection standards
For the safety of the equipment, the cabinet must be forced to remove heat. Most of the equipment is front suction and rear exhaust. It is required to install fans 4 & 6 on the bottom of each cabinet.
Cabinet Fan: High-speed hydraulic axial fan. Power is required to ensure the operating temperature of the equipment in the cabinet. The fan is equipped with a temperature control switch to control the fan switch. Reduced room noise. Fan power> 25W, speed >100001 rpm.
The cable management board is used for multiple cables.
Four dustproof inlet holes are provided on the top and bottom of each cabinet, with two front and two rear. Take two power cables and two data cables. Use a sponge and a rubber pad for dust prevention to prevent the cabinet iron from scratching the cables.
After installation, the fireproof mud must be used for fireproofing.
All communication cables under the floor must be protected by PVC pipes. In all cables under the floor, every 3M must be tagged and used on the PVC pipe.
Cable laying should be performed using N+1 redundancy. More than one set of spare cables must be reserved.
